I’m trying to make stairs in Avanti and move them around. First stage is to draw a triangle on the ground

And then “turn on end”. But it’s partly sunk into the ground. Using my cursor I can move the steps left / right and forward / back, but not up / down. I can’t pull them out of the dirt.

When I “orbit” the work area around just right, you can see part of the steps projecting below the surface of the ground.

I bet there is a way to move the steps up / down, but I can’t figure it out.

Meanwhile, when I go to Minecraft to see my handiwork, THIS is what appeared!!!!!

Notice the horse and sheep staring at it in bewilderment.

I’ll talk to my Computer Support team about this. Did Avanti save the wrong information (saved a file with different information than the image it showed me) or did the mess-up occur in the transfer between Avanti and Minecraft? …Or could it be a problem, not with the software, but…..WITH THE HARDWARE?!?!